E6000 gets tacky in about 2 minutes and cures in 24 hours, or up to 72 for a thick bead. When it sets depends on where you read: about 10 minutes on its FAQ, 45 minutes on its data sheet.
Each E6000, in its maker’s figures
| Product | Tack or set | Full cure | Apply at |
|---|---|---|---|
| E6000 (craft and industrial) | Tacky in about 2 minutes; set about 10 minutes (FAQ) or 45 minutes (data sheet) | 24 hours thin; 48 to 72 hours thick | 50 to 90°F |
| E6000 Plus | Working time about 25 minutes; tack free 30 to 55 minutes | 24 hours; up to 72 | 50 to 90°F |
| E6000 Premium | Set about 20 minutes | 24 hours; up to 72 for maximum strength | 50 to 90°F |
| E6000 Fabri-Fuse, Fray Lock | Work time 3 hours; set 3.5 to 4 hours | 8 hours; wash after 72 hours | 40 to 90°F |
| E6000 Extreme Tack | Stays tacky | 8 hours before mounting; wash after 72 | 40 to 90°F |
| E6000 Spray Adhesive | Not stated | Paper, photos, cardboard, foil: 1 to 3 minutes; porous and non-porous: 1 to 5 hours; Styrofoam may need overnight | 50 to 130°F |
| E6000 QuickHold | 10 to 12 minutes | 3 to 5 hours thin, 5 to 8 thick (data sheet) | Best 70 to 90°F |
| E6100 | Tack about 4 minutes; set 20 minutes (data sheet) | 24 hours thin; 48 to 72 thick | 50 to 90°F |
| E6800 | Tack about 2 minutes; set 45 minutes (data sheet) | 24 hours thin; 48 to 72 thick | 50 to 90°F |
From each product’s page, FAQ and data sheet. The E6100 and E6800 pages say tacky in about 2 minutes and setting in about 10; QuickHold’s FAQ says a full cure takes 2 to 6 hours, and its page directions say 5 to 8.
Why it takes so long
Eclectic’s data sheets say E6000 hardens by solvent evaporation, and give a thin film 24 hours and a thick one 48 to 72 to cure. Its FAQ says temperature and humidity affect the dry time, and that a handheld dryer set on low can speed it, as long as you don’t hold the heat directly on the glue.
E6000 Plus is different: Eclectic says lightly misting the surface with moisture speeds its cure, and that impermeable materials need longer. QuickHold’s FAQ says lower temperatures and higher humidity slow it. The fabric glues take longer the colder it is.
E6000’s data sheets say it may thicken when stored cold; warm it to room temperature before use. Eclectic says E6000 is photo-safe only after a full cure.
What does E6000 stick to?
Glue finder